The braid ear is one of the most classic hairstyles realized and appreciated, to be able to have an increasingly ordered in a few minutes we can braid the long hair to get a hairstyle elaborated for effect, to stop with just a rubber band, here’s a simple guide on how to make a braid in the ear. To create a braid to spike beautiful and voluminous is obviously necessary to have long hair, and possibly straight or wavy. The greater the length, the more the effect will be better and flashy. First, comb the hair thoroughly, freeing them from all nodes.

how to make

To give more volumizing effect and facilitate the fold, we can apply a mousse on the foliage, from massage until completely absorbed. For those who have a cut climbed, you may need the gel better to stop the strands, which tend to come out at the sides of the braid.

Let’s start from the lock that is located more to the left, passing over the middle and below the right and so on. We’ll have to be careful to move the hair in order, keeping them well separated and pulled, to have a beautiful braid and adjust . If discarded in some places, it is preferable to start to get a perfect result.

For more elaborate hairstyles, we can start the braid from the top of the head with three separate strands and add the other hair gradually to include them all. We begin by dividing the hair into three parts, separating them with care and positioning them well apart.

The braid is very convenient to collect hair while we are working and so we avoid to stop in the same spot with the ponytail: this will ruin less. We can also roll up on itself and stop the plot to obtain an elegant chignon. Let us now take the lock at the left end and, holding all three strands with hands, weave the first inserting it into the space between the other two and bringing it out from under the left. Now we take the one that is located on the far right with the same system, bringing it out of the space between the other two.

Once the composition of hair, let’s take a few centimeters before the end of the hair and stop them with a tight elastic and robust. To prevent the melt after some time, especially if we have an irregular cut, we spray a layer of lacquer on the entire surface and possibly put of hairpins as reinforcement at the points where it tends to discard.